A standard 1 HP (horsepower) water pump typically requires between 800 to 1200 watts of solar panels. This usually translates to three 400W panels or twelve 100W panels.
That panel produces up to about 13-14 amps with a voltage range up to about 51v depending on temperature, higher in cold temperature. It should work with pretty much any MPPT you will find.
During charging, air is refrigerated to approximately -190 °C via electrically driven compression and subsequent expansion. It is then liquefied and stored at low pressure in an insulated cryogenic tank.
Figure 1: Solar cell diagram illustrating the working principle based on the photovoltaic effect. Figure 1 shows a schematic layout of a p-n junction based solar cell. Here the n-region is heavily doped and the n-region is made thin so that maximum sun light can penetrate.
A solar booster pump works by converting solar energy into electricity to power a motor. This motor drives an impeller or other mechanism, which increases water pressure. A pressure switch automatically turns the pump on when pressure drops and off when it's restored.